Sound source has been switched ...

[ebfourie]

Using v0.92 on Samsung Tab A. Connecting to Yaesu 857D via DigiRig.

Receiving works ok, but I get the following error every couple of transmit cycles:

Communication error with rig
The rig connection is broken
The sound source has been switched

It then pops up the port selection dialog, and goes back to working.
Error seems more frequent when I increase output power. Typically run 30W for FT8, but getting the error quite often above 15W.

At the start of testing I got the "ALC too high" message. Reduced the DIG GAIN on the Yaesu 857 from 50 to 20. Seems to solve that issue. Audio out slider in FT8CN is at 25%.

I've selected "YAESU FT-857" option under Rig. Only other change I can think of was to increase the baud rate to 38400, as that is what I've previously run the digirig at.

Any ideas or suggestions pls ?