ioBroker.jeelink

This is an adapter for ioBroker to integrate RFM12B/RFM69 via Jeelink. The jeelink can be used with the preloaded software (rfmdemo) for the reading of openenergy sensors (emon). For the usage of LaCrosse sensors, the firmware has to be exchanged (see iobroker forum).

Installation:

released version

npm install iobroker.jeelink

on raspberry it might help to use:

 npm install --unsafe-perm iobroker.jeelink

because serialport package must be built on unsupported arm-hw

the actual development version from github (when under testing, may not work!)

npm install https://github.com/foxthefox/ioBroker.jeelink/tarball/master --production

or

npm install --unsafe-perm https://github.com/foxthefox/ioBroker.jeelink/tarball/master --production

Settings:

• USB port of JeelinkAdapter usually /dev/ttyACME
• Serial Speed usually 57600 Baud

Configuration:

to be done in admin

• deinition of the USB port
• setting the baudrate

• define sensor address which is received on air
• define unique sensors address within adapter (LaCrosse changes the on air address after battery change, so observe the log and adjust the sensor address after battery change)
• define the type of sensor (see belows examples)
• define the room

Sensors

Object	device variants	telegram example	Description
emonTH	emonTH	OK 19 ...	sensor from openenergy.org
emonWater	emonWater	OK 21 ...	sensor with RFM12B for water metering
LaCrosseDTH	TX	OK 9 ...	sensors from LaCrosse, technoline
HMS100TF	TXH29DTH-IT	H00 ...	sensors technoline
LaCrosseBMP180		OK WS ...	sensor mod, superjee
LaCrosseWS	WS1080,TX22,WS1600	OK WS ...	Weather Station
EC3000	EC3000	OK 22 ...	Energy Meter
EMT7110	EMT7110	OK EMT7110 ...	Energy Meter
level	level	OK LS ...	level sensor

TODO:

• other sensor types
• put the sensor code in separate file
• pushing new sensor to config, then visible in admin/config page
• HMS100TF Temp below 0°C and battery low to be implemented

Changelog:

0.0.7

• new level sensor (fhem)

0.0.6

• last version of serialport
• new sensor TXH29DTH-IT
• new weather station WS1600
• new sensor EC3000, EMT7110 not verified with life data

0.0.5

• adminv3 improved with values2table

0.0.4

• command to USB-stick for configuration
• added superjee, BMP180 sensor on jeenode
• admin v3 implementation

0.0.3

• abs humidity and dewpoint calculation

0.0.2

• definition of unique sensor ID for iobroker datapoint
• implementation of LaCrosseDTH
• definition of sensors via admin

0.0.1

• working with 3 sensors emon

License

The MIT License (MIT)

Copyright (c) 2018 foxthefox [email protected]