Skip to content

Latest commit

 

History

History
113 lines (90 loc) · 3.95 KB

README.md

File metadata and controls

113 lines (90 loc) · 3.95 KB
Raw

CircuitPlayground Software

General Setup

Follow the Adafruit tutorial to get the board initially setup. Make sure to update the bootloader and download any drivers that are needed.

Quick Reference:

After setup, copy over the contents of either the satellite or ground onto the board. To use the chatbot, run the twitch code on a device connected to the ground station CPX over serial

Challenges

LEDs

LED Challenge Notes
0 Maintenance Password Turns yellow if they enter the normal password first
1 Secondary Control Antenna Swings servo representing control antenna
2 Primary Control Antenna Flashes the completed color before turning back to normal if they haven’t finished the secondary control antenna
3 Disable battery charging (Solar Panel 1) Changes to the user position for a second before switching back if Primary Control antenna hasn’t been changed
4 Disable battery charging (Solar Panel 2) Changes to the user position for a second before switching back if Primary Control antenna hasn’t been changed
5 Disable temperature controller Will flash as a success for a second, before resetting if the primary control antenna hasn’t been changed
6 Override emergency failsafe Lets them override the final settings
7 Update Orbit Parameters Will be rejected while the flight systems are working, these get disabled by the failsafe override
8 Launch thrusters Either cause the sat to spin or smoke
9 Free Play User discovers one of the two free play command

State Map

  • 0: Default/Game Start
  • 1: User has entered normal password
    • Return health status
  • 2: User has entered maint password
  • 3: Adjust secondary antenna
    • Set
    • Status
    • Calc
  • 4: Adjust primary antenna
    • Set
    • Status
    • Calc
  • 5: Disable Solar Panel 1 but not 2
    • Enable
    • disable
  • 6: Disable Solar Panel 2 but not 1
    • Enable
    • disable
  • 7: Disable both Solar Panels
  • 8: Disable Temperature Control
    • Set
    • status
  • 9: Override failsafe (orbit)
    • mode
  • 10: Update orbit
    • Status
    • set
  • 11: Launch thrusters
    • ignite
  • 12: Free Play mode
    • Led
    • servo

CheatSheet

  • !cmd login twitch_handle password
  • !cmd login SpaceMaint 5p4c3d07c0m
  • !cmd ant calc x y z
  • !cmd ant set sec xyz
  • !cmd ant set pri xyz
  • !cmd bat disable pri
  • !cmd bat disable sec
  • !cmd temp status
  • !cmd temp set -20 100
  • !cmd orbit mode man
  • !cmd orbit set inclination 2
  • !cmd orbit ignite
  • !cmd servo 1 45
  • !cmd led 1 175 255 50

Troubleshooting Notes

Very frustrating to be developing quickly with read/writes/executes to a CircuitPlayground Express only for soemthing to hangup and the process fail with an failed unmount or data corruption.

Backup code

Back up code.py somewhere other than the Circuit Playground Express.

Input/Output Errors

This happened a few times, here's what worked to reset the device.

# observe how the circuit mounted
dmesg

# if mounted with errors
umount /dev/sda1  # verify the correct device first (i.e. sda1)

sudo fsck /dev/sda1

Clean Power Supply

Haven't done the math yet, but from observation the pi0 GPIOs being the exclusive power supply of the CPE, led diming was observed when sending commands to change values along with intermittent soft reboots. It is therefore recommended that power to the CPE be provided from other than the pi0.