8.0 RC2 Hanging on "waiting for data" page

[dcan999]

Speedybee F405 Mini, INAV 8.0

90% of the times I click reboot and save after adjusting something, in any tab, it will just hang on the "waiting for data" page and I have to unplug/replug the USB.

[0crap]

Same here, usually clicking the Disconnect/Connect button a few times solves the issue.
Does not happen with the 7.1.2 Configurator.
Matek F405-STD

For me it pretty much happens always after a new flash (full chip erase) and selecting "Airplane without a tail" from the "Default values" selection box. After the FC does it's reboot it shows the above screen and hangs.
When just changing a single setting and clicking the "Save and Reboot" button it usually works fine.

[dcan999]

It's been hanging up for me since 6.0 on full chip erase/resets but only when I initially do the reset/erase...on 8.0 it's hanging after almost every "save and reboot" I do regardless of how much I had changed. I also tried it today on a Matek 405WMN and it does the same.

[breadoven]

Try clicking the "Flush settings cache" button in the main application settings box, Also restart Configurator after flashing and flushing the settings cache.

[0crap]

Try clicking the "Flush settings cache" button in the main application settings box, Also restart Configurator after flashing and flushing the settings cache.

This could work as a temporary work-around.
As with the v7 Configurator, this should not be needed to do.

[b14ckyy]

I can confirm that this issue still occasionally appears, in my case only through slow wireless connections like Bluetooth or mLRS Data Links.
A quick disconnect and reconnect solves it but not reliably repeatable.

[zahachtah]

exact same issue Speedybee F405 Mini, INAV 8.0, FC FIRMWARE7.1.2 [SPEEDYBEEF405WING]

on mac

it will just hang on the "waiting for data" page when I try to go to Mixer tab and I have to disconnect and reconnect EVERY time to make it responsive again (until I click Mixer tab again and it hangs).

The Flush settings cache did not make any difference....

Any more ideas?

[b14ckyy]

Can anyone who has this issue at a high rate and only on wings, please go into CLI and type:

set looptime = 1000

then save. Please check if that reduces the rate of this bug. Quads should stay at looptime 500 though.

[zahachtah]

I "solved" the problem after seeing inav 8-0 only wants 8-0 firmwares for the FC, and as I wrote in previous post: INAV 8.0, FC FIRMWARE7.1.2....

All works when using INAV 7.x

@b14ckyy do you want me to test the loop time fix for the INAV 8.0, FC FIRMWARE7.1.2 combo or is that then irrelevant?