-
Notifications
You must be signed in to change notification settings - Fork 2
/
README.factory_stick
92 lines (43 loc) · 2.28 KB
/
README.factory_stick
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
To build a assembly factory stick which will install with full DRM protection.
All content is extracted from the database specified in factory_linuxrc
1. Setup database
Execute step 1,2 and 4 from README.db_setup
2. Check out the code and change into the directory
svn co svn+ssh://[username]@feuerworks.dyndns.org/home/svn/magden/dist/jway/trunk jway
cd jway
3. cd into jway directory.
All the following instructions assumes that you are in this directory
4. Load database logins
. setup.sh
5. Build kernel
make kernel
6. Create os packfile in database
sudo sh create_os_db.sh
7. Create m1e binary packfile in database
make m1e_db
8. Create jway_core skin and check into database.
make db DSKINS=jway/jway_core
9. Add serial number batch to database
Either do
./jway/bin/gen_m1_serial -d magdenus_trusted -p [xxx] -h [host:port] -dmagdenus_trusted -n [batch size]
or import keys from the batch found in ../web/serial_batches.sql (containing offial serial numbers)
10. Add magden and demo keys to database.
cd m1/core/trunk/keys
../../../../bin/add_key -d magdenus_trusted -p [xxx] -h [host:port] -dmagdenus_trusted -k demo
../../../../bin/add_key -d magdenus_trusted -p [xxx] -h [host:port] -dmagdenus_trusted -k magden
11. Create stick.
Insert stick into computer. And make note of the device it gets assigned (/dev/sda).
sudo sh create_factory_install.sh /dev/sdb 192.168.0.20 192.168.0.151
The "/dev/sdX" is replaced with the assigned USB stick device. It will be wiped so
make sure it is the right device.
[THIS WILL BE CHANGED USE 1 FOR NOW] "1" is the assmebly station using the stick.
The M1 unit will look into the database table trusted.assembly_station where the "id"
column matches the "1" number to figure out which lots were used to assemble this unit.
The "192.168.0.20" is the local IP address that the M1 unit should use while being installed. Make
sure that it is unique on the LAN.
The "192.168.0.151" is the IP address of the database server hosting the "magdenus_trusted" database
12. Setup m1 BIOS according to README.BIOS_settings.
Set Advanced BIOS Features - First Boot Device to USB-ZIP
13. Insert factory stick into M1 unit and boot it.
14. Power cycle when install is done.
Wait until install is complete. Remove stick and power cycle the M1