RMT error message box told me to forward PMTableDump to the devs.

[KirkH420]

Machine: ASUS Zephyrus G15 GA502IV
CPU: 4900HS
WinVer: Windows 10 LTSC (build 19044.1766)

I'm getting this message box on program launch. It didn't start happening the first time that I ran RMT 1.3b, I tried changing some settings and then it began popping up. I've messed around with this thing for a couple days now and I'm unable to get it to make any differences in Cinebench. RMT is unable to set the PL2 Fast Limit, from the factory it's 65 (which is probably way too high for a 35W chip). I was hoping I could lower it because there is virtually no ramp from idle temp to 97C. It just instantly peaks to the max in 1 second.

Anyway, when I try to change PPT LIMIT FAST, to something lower, RMT says the setting was applied but I can check with RyzenAdj and it tells me that it's still set to 65. Then when I run Cinebench there's no differences in performance. However, I think the values DO actually change because I can watch them with the CPU Power Sensors panel. But after 3-5 seconds, my system reverts it back to default. All of the settings revert to default. I even tested it while Cenibench was running a test and I can see with MSI Afterburner's hardware monitors, the values change when I hit "Apply" but a few seconds later it returns to default.

I realize that my CPU isn't listed as a supported chip, but at this point I've become pretty convinced that this software doesn't work for the 4900HS. Hopefully some day it will. Anyway, here's the TableDump that the messagebox asked me to send to you.

Thank you for working to create software like this. If there's anything I can do to help the 4900HS become a supported CPU, please let me know.

PMTableDump.log

[fyby]

Hi, same for me on 6800HS (Asus rog flow X16)
PMTableDump.log
.