Skip to content

Latest commit

 

History

History

arty_a7

README.md

SatCat5 Arty A7 Example Design

SatCat5 Logo

Overview

We provide an example design for the Digilent Arty A7 board that can be used with the Python chat app or your own code to try out SatCat5.

The design provides four UART ports on the PMOD connectors, one 10/100Mbps Ethernet port connected to the FPGA MAC over RMII, and a status LCD interface on the ChipKit IOs.

Building

The design has been tested on both Arty A7 35T and 100T variants with Vivado 2015.4, 2016.1, 2018.2, 2018.3, or 2019.1. Follow these steps to build the design and deploy to your Arty A7 board.

  1. Obtain and install Digilent board files for Vivado.
  2. Launch the Vivado GUI.
  3. From the Vivado TCL shell:
    • Navigate to the SatCat5 folder. e.g., cd path/to/satcat5
    • Run either set argv 35t or set argv 100t to select the appropriate hardware variant.
    • Then run the following commands: 
      cd examples/arty_a7
source create_project_arty_a7.tcl
  4. Connect an ethernet cable and up to 4 USB-UART cables (or Digilent PMOD USB-UART adapters) to the board and PC. If using 2-wire UART tie the CTSb line (pin 1) of each port to ground (pin 5).
  5. Open jumper JP1 to load bitstream with JTAG and program the device in Vivado. The .bin files generated in examples/arty_a7/backups can also be used to program the SPI flash.

Notes

  • When using a design stored on the SPI flash, you may need to press the reset button after powering the board if power is applied through the micro-USB header.

Running the Chat Demo

  1. Once the board has been connected and programmed as described above, follow the readme in test/chat_client to install dependencies for the chat demo.
  2. Run the chat demo with python3 chat_client.py, selecting the configuration and status UART (provided over the micro-USB programming cable) and your UART PMOD and ethernet ports.
  3. Enjoy testing SatCat5 performance!

Notes

  • The UART ports are fixed at 921,600 baud by default in the example design and the ethernet link operates at 100Mbps unless forced to 10Mbps by lowering GPO_RMII_FAST in switch_cfg.py.
  • The RESET button may be pressed to reset the switch logic and ethernet PHY without reloading device configuration.

Copyright Notice

Copyright 2019-2023 The Aerospace Corporation.

This file is a part of SatCat5, licensed under CERN-OHL-W v2 or later.

You may redistribute and modify SatCat5 and make products using it under the weakly reciprocal variant of the CERN Open Hardware License, version 2 or (at your option) any later weakly reciprocal version.

SatCat5 is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY, AND FITNESS FOR A PARTICULAR PURPOSE. Please see (https:/cern.ch/cern-ohl) for applicable conditions.