Home-Assistant Config by @eiddor (layout ideas stolen from @ccostan)

Home Assistant configuration files (YAMLs)

Welcome to my Home Assistant Configuration. It's more or less complete for now, but I tend to tinker with things as I learn more about it.

Home Assistant runs on my Raspberry Pi 3 with Aeon Labs Z Wave Stick (GEN 5).

Software on the Pi : Home Assistant, OpenZwave Control Panel, and Homebridge with Homebridge-homeassistant for Siri control

List of devices :

• Amazon Echo
• Amazon Dash Buttons
• Philips Hue Starter Kit Gen 3
• GE Z-Wave On/Off Switch
• GE Z-Wave Smart Dimmer Switch
• GE Z-Wave Outdoor Module
• GE Z-Wave Fan Control Switch
• GE Z-Wave Receptacle [not yet installed]
• Aeotec DSB45 Water Sensor
• Aeotec ZW096 Smart Switch
• Aeotec ZW100 Multisensor
• Rokus [not currently added my Home Assistant]
• Plex Media Server
• Logitech Harmony Smart Control
• Garadget
• LEDENET Smart WiFi LED Controller
• Remotec ZFM-80 Z-Wave Contact Fixture Module
• LED Strips

Automations:

• Turn on Porch Lights at Sunset, off at Sunrise
• Turn on Christmas Lights at Sunset, off at Midnight
• Turn on Guest Room Lamp at 5 PM, off at 8 AM
• Check for Home Assistant Releases and notify via Pushbullet
• Turn On/Off Bedroom lamp when Dash Button event is called via API [script running on different host]
• Turn theater lights on in Media Room on motion detection for ten minutes if no one is watching something via the Logitech Harmony Hub
• Local backup of all configuration files at 1 AM

Time Based Automation TimeLine (a WIP)

SUNRISE:
     Turn off Porch Lights

SUNSET: 
     ~~Turn on Christmas Lights~~ (Christmas is over)
     Turn on Porch Lights

05:00 PM Turn on Guest Room lamp for one of the cats
11:59 PM Turn off Christmas Lights
01:01 AM Backup HASS Configuration Files
02:31 AM Heal ZWave Network
08:00 AM Turn off Guest Room lamp

#Todo List

• Install GE Z-Wave Outlets
• Enhance the Media Room motion sensor to turn off lights after a period and check for Lux condition [changed this to detect when there is activity via the Harmony Hub]
• Add Harmony Hub when it arrives
• Configure a clever automation for when the Water Sensor is triggered (it's in a closet with my water heaters)
• Add more sophisticated control of my Hue lights
• Buy some Hue LED strips OR
• Build a DIY LED setup using LEDENET or this or this, some code, and some of these or these (Basic LED strip install complete)
• Buy and install WS2812 LED strips, controller, etc.
• Install the third Hue bulb
• Install an Aeotec smart switch and power relay to control the fireplace (Used the Remotec ZFM-80 instead)
• Setup my two remaining Amazon IoT buttons to do something
• Purchase some kind of doorbell/camera
• Purchase some Z-Wave compatible thermostats
• Purchase a Z-wave compatible garage door opener/sensor Garadget
• Add a couple more Aeotec Multisensors around the house and mess with the family
• https://github.com/thundergreen/home-assistant/wiki/Add-OZWCP-in-HASS
• Taking suggestions!!!