heltec lora v3

[tofuatjava]

Hi,
I'am OE5TFR and have done little changes to support th newer heltect lora v3 boards with the ESP32-S3 chip.

[dc5on]

[INFO][BoardFinder] searching for OLED...
[ 844][I][esp32-hal-i2c.c:75] i2cInit(): Initialising I2C Master: sda=4 scl=15 freq=100000
[ 851][I][esp32-hal-i2c.c:75] i2cInit(): Initialising I2C Master: sda=21 scl=22 freq=100000
E (646) i2c: i2c_set_pin(875): scl gpio number error
[ 864][E][esp32-hal-i2c.c:88] i2cInit(): i2c_param_config failed
[WARN][BoardFinder] issue with wire
[ 880][I][esp32-hal-i2c.c:75] i2cInit(): Initialising I2C Master: sda=21 scl=22 freq=100000
E (669) i2c: i2c_set_pin(875): scl gpio number error
[ 887][E][esp32-hal-i2c.c:88] i2cInit(): i2c_param_config failed
[WARN][BoardFinder] issue with wire
[ 903][I][esp32-hal-i2c.c:75] i2cInit(): Initialising I2C Master: sda=21 scl=22 freq=100000
E (692) i2c: i2c_set_pin(875): scl gpio number error
[ 910][E][esp32-hal-i2c.c:88] i2cInit(): i2c_param_config failed
[ 915][E][Wire.cpp:526] write(): NULL TX buffer pointer
[ 920][E][Wire.cpp:448] endTransmission(): NULL TX buffer pointer

[dc5on]

With Parameterchange on "BoardConfig TTGO_Lora32_V1" it will start without LORA

[Ingineerix]

Awesome Guys! Thanks for adding support for the Heltec V3. I have it working great on the SX1262 at 915MHz. Only problem it has is WiFi, when it initially connects if I do not start a high volume of pings to it from another device, the WiFi radio will lose connection and not make it to connecting to APRS-IS. But with the high-rate ping in place it connects, and then I can stop the ping and everything is normal. I opened an issue here: #324